A traditional deep cornice with curved features.
Suitable for ceilings up to 11ft / 3.4m.
Ideal for both modern and period properties.
Measures approximately 3 metres
Projection – wall 15.5cm x ceiling 21cm
It is recommended that before fitting, to cover the back of the plaster moulding or cornice with one coat of PVA sealant, available from your local DIY store or builder’s merchant. Additionally, PVA the area of wall or ceiling the moulding is to be attached to.
Place the coving into the mitre box with the wall edge at the top of the box.
Use a fine-toothed panel saw to make 45-degree mitre cuts at each end
To fit the coving, start by hold the cut piece in position to check it is a good fit, then remove your piece of coving and apply adhesive.
Align the coving with the lines on the wall and ceiling, then work your way along, carefully pressing it into position. It’s a good idea to lightly hammer panel pins into the wall to hold the coving in place, whilst the adhesive sets.
Fill any remaining gaps between adjoining pieces of coving, or between the coving and the wall or ceiling, by squeezing in a little extra filler. Sand all joints before applying any paint.